Xen Black Plastisol Ink for all fabrics

Xen Black Plastisol Ink

Highlights Xen Black :

• Non-phthalate ink
• Exceptionally opaque ink
• Creamy & soft, and very low wet tack for easy printing
• Tack-free formulation
• Very bright colors
• Outstanding printing because of the creamy nature of this ink and the ease of using the ink
• There is no need to add reducers as the ink is ready for use.
• Recommended for both manual and automatic machines

Application Recommendations for Xen Black Plastisol Ink:

1. Mesh 86-110: applying a heavier ink coat to white and light-colored fabrics is unnecessary.
2. 110-305 mesh count is ok for light-colored fabrics.
3. If you are printing black on color shirts, you may use 86 to - 305 mesh -
4. For lighter colors and white, use a mesh count of 160-305.
5. squeegee 60-80 A
6. Use any xenon product's direct emulsion to make screens; we recommend a high-solids one-part "Qxl" (45% solids). For a heavier deposit of plastisol ink for printing dark shirts, use a higher-solids emulsion and apply two coats: two on the print side and two on the squeegee side.
7. cotton and 50/50 cotton/polyester, and Polyester fabrics
8. One stroke of application is needed for white and lighter colors.
9. fully cured @ 285 F in the dryer for one minute and twenty seconds
10. The dryer has to be maintained so that the print temperature is 285-290F for 1 minute and 20 seconds to achieve complete fusion, which will give the print better washability and fusion. The ink sometimes does not fuse properly due to low voltage- Test the temperature with a laser gun. THE BEST COURSE IS TO CHECK ONE SHIRT OR PELLON FOR FUSION OF THE INK.
11. Do Not Dry Clean
12. Store at room temperature and avoid storing in direct sunlight/humid air.