Home > Adhesives > Blockout Solutions >

Screen Blockout WR (for water based ink)

Screen Blockout WR  (for water based ink)

ADD TO CART: $21.00

Product Code: A-2002

Size for Block wr*:


Screen Blockout WR (for water-based ink)

Screen Blockout WR blocks the screen's border and fills the pinholes after washing the exposed emulsion film. The pinhole issue is something that should not occur in the first place. It would be best to not get pinholes by degreasing and cleaning the screen properly with suitable emulsion and curing at the right time. If you are getting pinholes, there is something not done right.


  • Type: Water-based product
  • Color: Red
  • Viscosity: 12,500cps, Brookfield viscometer@ 20 rpm
  • Solids: 24%
  • Solubility in Water: 100%
  • Weight per gallon: 7.6 pounds.

Blockout or fillers may be used for filling the area that is needed on the screen and has to be blocked. The area that is not required for the ink to pass through is also blocked by tapes, but that is expensive and disruptive. Block Out may also be used to close pinholes on the screen. Block out WR is fast drying and recommended for water based ink.

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 1 Write a review »

  0 of 0 people found the following review helpful:
5 of 5 product worked as described August 31, 2017
Reviewer: Logan M  
product worked as described

Was this review helpful to you?