 |
Four-color process inks are transparent inks applied wet-on-wet. Xenon’s process inks are intense enough to achieve the desired colors.
HIGHLIGHTS:v
NON-PHTHALATE INK
CREAMY, SOFT, AND VERY LOW WET TACK FOR EASY PRINTING
TACK FREE FORMULATION
BRIGHT COLORS
GREAT PRINTING BECAUSE OF THE CREAMY NATURE OF THIS INK AND EASE OF USING THE INK
THERE IS NO NEED TO ADD REDUCERS AS THE INK IS READY FOR USE
RECOMMENDED FOR BOTH MANUAL AND AUTOMATIC MACHINES
APPLICATION:
Recommended mesh 86-110 and 60 to 80 durometer squeegee- You may need to apply a heavier deposit of process ink for coverage, depending on the desired color. Use 200-305 mesh count for fine lines.
USE ANY XENON PRODUCTS DIRECT EMULSION TO MAKE SCREENS- WE RECOMMEND HIGH SOLID ONE PART " QXL " (45% SOLIDS). For A Heavier Deposit Of Plastisol Ink, You Need A Higher Solids Emulsion And Application Of Two Deposit Of Emulsion, Two On the Print Side And Two On The Squeegee Side.
COTTON AND 50/50 COTTON / POLYESTER FABRICS
PRINT/ FLASH PRINT FOR DARK SHIRTS AND ONE STROKE FOR LIGHTER AND WHITE FABRICS
FULLY CURED @ 350 F
- The dryer has to be maintained so that the temperature at the print is 320-350F for 1 minute and 20 seconds to ensure complete fusion, which will give the print longer washability and fusion. The ink sometimes does not fuse properly due to low voltage- Test the temperature with a laser gun. THE BEST COURSE IS TO CHECK ONE SHIRT OR PELLON FOR FUSION OF THE INK.
- Do Not Dry Clean
STORE AT ROOM TEMPERATURE AND AVOID STORING IN DIRECT SUNLIGHT/HUMID AIR.
CAUTION:
DO NOT DRY CLEAN AFTER PRINTING
|
|
|
